Viking MAC OS Betriebsanweisung PDF herunterladen (Seite 15)

VIKING COMPONENTS 33.6K/56K PC CARD USER’S GUIDE

Remote Access/Mac PPP Setup

Viking Apple Modem Scripts and Mac OS 7.6 or later are required for this setup.

“

1. Insert the “Apple Modem Scripts” disk into your systems floppy drive. Copy the

three modem scripts to the “Modem Scripts Folder.” This folder is located in your

systems hard drive under the “System Folder,” then “Extensions Folder,” and finally

in a folder called “Modem Scripts.” After these files have been copied, remove the

floppy disk by dragging it to the trash.

2. From the Apple (



) menu, select “Control Panel” and then choose “Modem.”

Select the PCMCIA port that you have installed your modem. Then select one of

the following modem types to reflect your modem:

A) “Viking V90/56K” for V90/Flex connections.

B) “Viking Force 56K” for Flex only connections.

C) “Viking Force V.34” for 33.6K only connections.

Then close the “Modem” control panel and click “Save.”

3. From the Apple menu, select “Control Panel”and then choose “TCP/IP.” From the

“Connect Via” pop-up menu, choose “PPP.” From the “Configure” pop-up menu,

choose “PPP Server.” In the text box labeled “IP Address,” enter the IP address

given to you by your ISP. In the text box labeled “Domain Name,”enter the domain

name given to you by your ISP. Close the “TCP/IP” control panel and click “Save.”

4. From the Apple menu, select “Control Panel” and then choose “Remote

Access/PPP.” Enter your user name, password and phone number in their appro-

priate text fields.

Your software installation and setup is now complete.

Chapter 3

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 52 53

Keine Kommentare

Viking MAC OS Betriebsanweisung Seite 15