Viking RVER3305BSS Installationshandbuch PDF herunterladen (Seite 8)

1514

Legs are packed in styrofoam top pack.

Note: Legs should be installed near to where

appliance is to be used, as they are

not secure for long transit.

Note: It is strongly recommended

that a pallet or lift jack be used rather than tilting.

Raise unit about a foot.

Unscrew temporary legs from

couplings

Lower range gently to keep any undue strain from

legs and internal mounting hardware.

Screw legs into couplings on all

four corners.

Leg Installation

Remove access door.

Electrical Connection (3-wire)

Remove supply cord strain relief

bracket and three supply cord mounting screws

on terminal block.

WARNING

ELECTRICAL SHOCK

HAZARD

To avoid risk or electrical

shock, personal injury or death;

grounding product to the frame of the unit

may or may not be permitted through

your local codes. If ground to the frame is

not permitted then a 4-conductor power

cord must be used.

WARNING

ELECTRICAL SHOCK

HAZARD

To avoid risk of electrical shock,

personal injury or death; verify

your appliance has been properly

grounded in accordance with local codes

or in absence of codes, with the National

Electrical Code (NEC). ANSI/NFPA-70 –

latest edition.

Feed supply cord up through hole in bottom

of range back.

Note: If you have a 4-wire connection, see following section for

4-wire connection instructions.

See Electrical Requirements information.

Where local codes do not permit grounding

through neutral, use a 4-wire power supply

cord. The cord or conduit must be secured

to the range with the strain relief bracket.

The electrical connection is made at the

terminal block, which is located behind the

access door on the back of the range.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Viking RVER3305BSS Installationshandbuch Seite 8

Kommentare zu diesen Handbüchern