1
Note: Refer to range electrical
requirements section for proper
installation information.
Connect electrical in shaded area. See the “Electrical
Requirements” section for more information.
Final Installation
2
Slide range into place. Be sure anti-tip
bracket slides into the anit-tip opening.
3/8”3/8”
(0.95 cm)(0.95
cm)
3/8”
(0.95 cm)
3
Check that unit is level side to side
and front to back. The side trim must be 3/8” (0.95 cm)
above countertop. If unit is not level repeat Steps 5-7
of “Leveling/Adjustments/Alignment” section.
Reattach door to range.
Open door completely. Reattach hinge trim.
Remove pins from hole in hinges.
Close door.
If the door needs to be adjusted, loosen hinge trim screws (see Step 2).
Adjust the screws located between the door and kickplate using a 5/32”
hex head allen wrench. After adjustment, tighten hinge trim screws.
Door Replacement and
Adjustment
3
Remove two screws from back of range.
Attach bracket to back of range using two screws.
5
Slide range into place and check that hook and bracket
are engaged.
Floor Mount Anti-tip Installation (cont.)
Kommentare zu diesen Handbüchern