Measure from floor to bottom
of the anit-tip opening located on the back of range.
This will be measurement (A).
Locate anti-tip bracket on rear wall with the top left corner at
measurement (A) plus 1/2” (1.3 cm) from the floor and 3-5/8” (9.2 cm)
from where the right side of range (facing range) is to be located.
Locate anti-tip bracket hook on the floor
8-1/2” (21.6 cm) from side cabinet and 1-1/2” (3.8 cm) from rear wall.
Mark and drill 1/8” (.32 cm) holes where bracket will be located.
Set the high corner of range so that the top of side trim is
3/8” (0.95 cm) above countertop. Level range to high corner.
Anti-tip Device Installation
TIPPING HAZARD
To reduce the risk of the
appliance tipping, it must be
secured by a properly installed
anti-tip bracket(s). To make sure
the bracket has been installed
properly, look behind the range
with a flashlight to verify proper
installation engaged in the rear
top left corner of the range or under the range
to verify that a floor hook and bracket have
been installed.
Your range is shipped standard with two
types of anti-tip devices.
Type 1 is a wall mount device
which can be used for all
installation applications.
Type 2 is a floor mount
device which can be used for
all applications other than
when the range is installed
on a concrete sub-floor.
Important – The range MUST be installed
with one of the anti-tip devices.
Attach bracket with
mounting hardware provided.
Wall Mount Anti-tip Installation Floor Mount Anti-tip Installation
Leveling/Adjustments/Alignment (cont.)
Kommentare zu diesen Handbüchern