Viking F-1 Installationshandbuch PDF herunterladen (Seite 6)

VIKING TECHNICAL SUPPORT 1.800.908.0884

4

CONTROL BOARD REFERENCES:

1.

POWER HARNESS CONNECTOR

provides power to the control board.

pg 18-19

2.

“OPEN LEFT” & “OPEN RIGHT”

provides power to the motor. pg 20

3.

LIMIT SETUP BUTTONS

available for future developments.

4.

FEATURE ACTIVATION TRIM POTS

activate and set features. pg 24

5.

“EPS1” CONNECTOR

available for future developments.

6.

“EPS2” CONNECTOR

available for future developments.

7.

EMI BOARD CONNECTOR

monitors the high voltage power

supply.

8.

“CHECK MOTOR” Status LED

indicates motor power status. pg 36

9.

“BATTERY LOW” Status LED

indicates battery power status. pg 36

10.

“POWER” Status LED

control board power status. pg 18,36

11.

“MAGNETIC LOCK RELAY” Status LED

status of this on-board relay. pg 34, 36

12.

“MAGNETIC LOCK RELAY” Terminal Block

connect electric locks here. pg 34, 36

13.

INPUT STATUS LEDs

indicates input status. pg 36-37

14.

ACCESS CONTROL TERMINAL BLOCKS

accessory connections. pg 29-32, 42-44

15.

“MASTER/SLAVE” Terminal Block

wired master/slave connection. pg 22

16.

CONTROL BOARD MOUNTING HOLES

secures and grounds the control board.

17.

“Siren” Terminal Block

Vikings UL Siren is connected here.

18.

ON-BOARD 3 BUTTON STATION

controls the gate during set up.

19.

“AUX. PWR” Terminal Block

used for solar applications & in-motion

warning devices. pg 19, 25

20.

FEATURE ACTIVATION PIN HEADERS

activate features by placing a jumper

onto the pin headers. pg 25

21.

“DIAGNOSE” Button

allows you to navigate through the

Diagnostics LCD Display. pg 38-40

22.

“DIAGNOSE” LED

informs that errors have been detected

and available on LCD Display. pg 38-40

23.

LCD DIAGNOSTICS DISPLAY

provides error messages, diagnostics

and operator status information.

pg 38-40

24.

EXPANSION PRODUCT CONNECTIONS

connections for additional products

from Viking Access Systems. pg 46

25.

“FAIL SAFE/SECURE” Jumper

power failure option. pg 25

26.

FUSE HOLDER - 15 AMP

for motor circuit.

27.

FUSE HOLDER - 4 AMP

for charging circuit.

28.

HEAT SINK

secures the control board and

dissipates heat.

1 2 3 4 5 6 7 8 9 10 11 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare