Viking F-1 Installationshandbuch PDF herunterladen (Seite 39)

VIKING TECHNICAL SUPPORT 1.800.908.0884

LED References

Use the table below to identify the corresponding “TS Ref#” and refer to page 38-41 for

further troubleshooting.

TROUBLESHOOTING

# LED Status Meaning

Pg 41

TS Ref#(s)

9 “C Loop” OFF Normal Condition.

SOLID Control Board is receiving an input from a device connected to the

C Loop terminal (pg 32, 42).

9, 10

10 “Open” OFF Normal Condition.

SOLID Control board is receiving an input from a device connected to any of

the following input terminals: Exit, Fire, Strike or Open (pg 31, 42).

9, 10

11 “STOP” OFF Normal Condition.

SOLID Control Board is receiving an input from a device connected to the

Stop terminal (pg 31, 42).

9, 10

12 “Close” OFF Normal Condition.

SOLID Control Board is receiving an input from a device connected to the

Close terminal (pg 31, 42).

9, 10

13 “Siren”

OFF Normal Condition.

SOLID Second consecutive obstruction has been detected. (pg 26).

11, 13, 1, 2

FLASHING Batteries are critically low.

1, 2

14 “Aux. Pwr”

OFF No voltage output on these terminals at the moment.

SOLID There is 24VDC output on these terminals at the moment.

15 “Diagnose” OFF Normal Condition.

FLASHING Errors have been detected; Check LCD Display for ERR messages (pg 40).

“Close Limit”

OFF Gate is not at the close limit position.

SOLID Gate is at the close limit position.

FLASHING Indicates a problem with the limit switches or wires. (pg 20-21).

“Open Limit”

OFF Gate is not at the open limit position.

SOLID Gate is at the open limit position.

FLASHING Indicates a problem with the limit switches or wires. (pg 20-21).

18 “ODS” OFF Normal Condition.

SOLID Obstruction has been detected. (pg 26).

11, 13, 1, 2

FLASHING Overload has been detected. (pg 26).

11, 13, 1, 2

19 “Timer” OFF The close timer is turned OFF or gate is not at the open limit if the timer is

turned ON. (pg 24).

SOLID Gate is at Open Limit, Timer is turned ON and counting down to close. (pg

24).

FLASHING Gate is at Open Limit, Timer is turned ON but is not timing out due to a

conictingcommand.(pg24).

9, 10

“AC VOLTAGE INPUT”

SOLID Normal Condition.

OFF IncomingpowertoPowerSupplyPanelAssemblyisnotsufcient.(pg18).

“PROTECTION WORKING”

SOLID Normal Condition.

OFF EMI Board is damaged and circuit is not protected . Replace EMI Board.

“AC VOLTAGE OUTPUT”

SOLID Normal Condition.

OFF There is no output voltage from the Power Supply Panel Assembly.

23 “AC POWER” SOLID Normal Condition for High Voltage installations.

OFF High Voltage is not supplied to the Modular Power Box (pg 18).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare

Viking F-1 Installationshandbuch Seite 39

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartenwerkzeuge Viking F-1