C. Factory Default Settings
Security Code
Access Code
Phone Numbers
Messages
Ring Delay
Ringback Limit
Dialing Speed
Hookswitch Flash
Before Dialing
845464 (V-I-K-I-N-G) (see section D)
123456 (see section E)
Not programmed (see section N)
Not recorded (see section R)
1 (see section F)
6 (see section G)
Normal (see section H)
Disabled (see section P)
Call Progress Detection
Alarm Input
Configuration
Lap Counter
Message Repeat Counter
Qualifier Timer
Resume Timer
Pager Number
PA Mode
Enabled (see section I)
N/O (Enabled) Momentary
(see section J)
1 (see section K)
2 (see section K)
0 - disabled (see section L)
0 - disabled (see section M)
Not programmed (see section O)
Disabled (see section Q)
E. Remote Access Code
Enter a six-digit access code followed by #91. Note: The remote access code must use only the digits 0-9, cannot
contain
Q
or #, and cannot be set the same as the security code.
D. Security Code (memory location #90)
The security code allows the user/installer to program the K-202-DVA either locally or remotely. The factory set secu-
rity code is 845464 (V-I-K-I-N-G). It is recommended that the security code be changed. Example: To store 654321
as the security code:
Step 1. Access programming as shown in Programming section A.
Step 2. Enter 654321 #90.
Step 3. Exit Programming as shown in section A.
Note: The security code must be 6 digits, cannot include a
Q
or a #, and cannot be set the same as the remote access code.
F. Ring Delay
Enter one digit from 0-9 followed by #92. If the ring delay is set to 0, ring detection is disabled, so that the K-202-DVA
will not answer incoming calls. It is important to note that this prevents Remote Access and Remote Programming.
G. Ringback Limit
Enter two digits from 01-99 followed by #93.
I. Forced Play Timer and Call Progress Detection
Call Progress Detection is enabled by setting the Forced Play Timer to 0, which is done by entering the two digits 00
followed by #94. Call Progress Detection is disabled by setting the Forced Play Timer to a non-zero value from 1 to 99
seconds. Enter a two digit number from 01- 99 followed by #94.
J. Contact Closures
Enter 2 digits + #X9, where X is the input number (1-2).
First Digit: 0 = normally open
1 = normally closed
2 = enabled
3 = disabled
Note: These parameters should be set for each input being used. If contacts are disabled through programming (3X),
they must be set for correct operation (N.O. / N.C.) and then enabled (2X) before they will function.
Second Digit: 0 = momentary closure
1 = continuous closure
H. Selecting Dialing Speed
To select normal dialing speed (120 ms) enter ##1. To select fast dialing speed (50 ms) enter ##2.
K. Message Repeat Counter and Lap Counter
Enter 4 digits + #X0, where X is the input number (1-2)
First two digits: 01 - 99 are the Message Repeat Counter
Last two digits: 01 - 99 are the Lap Counter
Note: Each input can have its own Message Repeat Counter and Lap Counter.
5
(10 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern